Monte Carlo V6-3.8L SC VIN 1 (2004)
1. Install the cruise control module on the mounting studs located on the shock tower.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the cruise control module mounting nuts.
Tighten
Tighten the cruise control module to shock tower nuts to 2 N.m (18 lb in).
3. Connect the cruise control module electrical connector.
IMPORTANT: The cruise control cable does not require mechanical adjusting after the replacement. The cruise control module internally adjusts
the cable.
4. Install the cruise control cable to the cruise control module.
