Monte Carlo V6-3.8L SC VIN 1 (2004)
12. If replacing the oil filter adapter and valve assembly, remove the engine oil pressure sensor from the oil filter adapter and valve assembly.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. If replacing the oil filter adapter and valve assembly, install the engine oil pressure sensor to the oil filter adapter and valve assembly.
-
Tighten the sensor to 16 Nm (12 ft. lbs.).
2. Install the spring to the engine front cover.
3. Install the oil pressure valve to the engine front cover.
4. Install the oil filter adapter and a new gasket.
5. Install the oil filter adapter bolts.
-
Tighten the bolts to 15 Nm (11 ft. lbs.) + 50 degrees.
