Monte Carlo V6-3.8L SC VIN 1 (2004)
5. Tighten the bolts to the right and left side of the cross vehicle beam in sequence.
Tighten
Tighten the bolts to 25 N.m (18 lb ft).
6. Install the bolts to the HVAC module upper support.
Tighten
Tighten the bolts to 4 N.m (35 lb in).
7. Install the bolt (1) to the left side of the HVAC module assembly lower support.
Tighten
Tighten the bolt to 4 N.m (35 lb in).
8. Install the bolt (2) to the right side of the HVAC module assembly lower support.
Tighten
Tighten the bolt to 4 N.m (35 lb in).
9. Reposition the I/P wiring harness on to the cross vehicle beam and secure the retaining clips.
10. Connect all disconnected ground wires.
11. Connect the electrical connector from the HVAC module assembly to main harness connector.
12. Install the three brake pedal brace bolts.
Tighten
Tighten the bolts to 50 N.m (37 lb ft).
13. Install the brake pedal.
14. Install the body control module to the cross vehicle beam.
15. Connect the wire harness connectors to the body control module.
16. Install the left side fuse block to the cross vehicle beam.
17. Install the bolts to the left side fuse block.
Tighten
Tighten the bolts to 10 N.m (89 in lb).
18. Install the right side fuse block to the cross vehicle beam.
