Monte Carlo V6-3.8L SC VIN 1 (2004)
3. Install the intermediate steering shaft seal onto the steering column.
4. Raise and support the vehicle. Refer to Vehicle Lifting.
5. Install the intermediate steering shaft (1) to the power steering gear stub shaft (2).
6. Install the lower pinch bolt which secures the intermediate steering shaft to the power steering gear stub shaft.
^
Tighten the pinch bolt to 48 Nm (35 ft. lbs.).
7. Remove the J 42640 from the steering column.
8. Install the intermediate steering shaft seal onto the power steering gear.
9. Install the tire and wheel assembly.
10. Lower the vehicle.
11. Install the left instrument panel insulator.
