Monte Carlo V6-3.8L SC VIN 1 (2004)
6. Remove the drain pan from under the forward servo cover.
7. Adjust the jackstand in order to raise the rear of the frame.
8. Install the frame bolts.
9. Remove the support from the rear of the frame.
10. Install the power steering lines to the right side of the frame.
11. Install the engine mount lower nuts.
12. Install the transaxle mount lower nuts.
13. Install the power steering gear.
14. Lower the vehicle.
15. Remove the engine support fixture.
Notice: Refer to Do Not Overfill the Transmission Notice.
16. Check and fill the transaxle as necessary.
