Monte Carlo V6-3.8L SC VIN 1 (2004)
Rear Door Window Glass: Adjustments
Window Adjustment - Rear Door
Causes of Slow Moving Glass
Caution: Disconnect the power window switch when working inside the driver door. When operated, the Express Up/Down Feature allows the
door window to move very quickly, without stopping, which could cause personal injury.
*
Owners may comment that the windows (door glass) operates slowly when going up or down.
*
Listed below are 4 conditions that may cause slow moving glass.
-
The glass run channel outboard lip at the rearview mirror is rolled over or the glass run channel outboard lip at the door rear, is rolled over (2).
-
The glass run channel is not seated at the door rear.
-
The glass is misaligned in the opening.
-
The regulator is misaligned causing misalignment of the glass.
Adjustment Procedure
1. Remove the rear door trim panel.
2. Remove the rear door water deflector.
Notice: Refer to Fastener Notice in Service Precautions.
*
Condition 2.3: Loosen the window to regulator bolts.
Rotate the cam (5) on the window regulator plate so that the slot (6) is straight up and down. In this position, the back of the glass will tilt
forward.
Tighten the 2 window to regulator bolts to 10 N.m (89 lb in).
*
Condition 2.4: Loosen the window to regulator bolts.
Loosen the 4 regulator bolts.
Now, tighten the window regulator bolts according to the tightening sequence(1,2,3,4).
Tighten the 4 window regulator bolts to 10 N.m (89 lb in).
Tighten the 2 window to regulator bolts.
Tighten the 2 window to regulator bolts to 10 N.m (89 lb in).
3. Connect the power window switch.
4. Install the rear door water deflector.
5. Install the rear door trim panel.
