Monte Carlo V8-350 5.7L DSL (1982)
Alignment: All Technical Service Bulletins
Alignment - Chassis Spring Shims, Trim Height Correction
85-83
3D
MAY, 1985
Subject:
CHASSIS SPRING SHIMS
Model and Year:
1977-85 REAR WHEEL DRIVE VEHICLES
TO:
ALL CHEVROLET DEALERS
Spring shims for minor correction of low trim height are available from GMWDD. The shims can be used on 1977 through 1985 rear wheel drive
vehicles as listed below:
1978 - 1981 - Malibu and Monte Carlo
1982 - 1985 - Monte carlo
1977 - 1984 - Caprice
1977 - 1985 - Impala
These shims are 1/8" thick, and no more than two (2) are to be used at each spring location. When used on a front spring, the vehicle's trim height at the
wheel opening will be increased approximately two (2) times the thickness of the shim. When used on a rear spring, the trim height will be increased
approximately the same amount as the thickness of the shims.
Part Description
Part Number
Shim, *Front Spring Upper
25524879
Shim, *Rear Spring Lower
25524880
*USE SHIMS ONLY AT LOCATION ON SPRING, AS SPECIFIED ABOVE.