Prizm L4-108 1.8L DOHC VIN 8 MFI (1998)
9. Place a box and wrench (3) over the bleeder valve (2).
10. Attach a transparent hose (1) over the bleeder valve (2).
11. Submerge the other end of the hose in an transparent container (5) filled with brake fluid (6).
12. Charge the pressure bleeder to 140-172 kPa (20-25 psi).
13. Loosen the bleeder valve (2) approximately one-half turn. The brake pedal should now fall all the way to the floor as the brake fluid flows out of
the bleeder valve and into the clear fluid container.
NOTICE: Refer to Fastener Notice in Service Precautions.
Tighten the bleeder valve (2).
^
Tighten the bleeder valve to 8.3 Nm (85.74 in. lbs.).
14. Inspect the brake pedal application.
15. Bleed the hydraulic brake system until the following conditions are met:
^
The brake pedal application does not feel spongy.
^
There is no air in the brake pipes or hoses.
^
There are no air bubbles in the clear fluid container (6).
16. Ensure the pressure bleeder is charged to 140-172 kPa (20-25 psi).
17. Inspect the hydraulic brake system for fluid leaks.
18. Remove the transparent hose (1) from the bleeder valve (2).
19. Remove the box end wrench (3) from the bleeder valve (2).
20. Repeat the hydraulic brake system bleeding procedure at each required wheel in order to bleed the entire hydraulic brake system.
21. Remove the pressure bleeder.
22. Install the reservoir cap.
23. Lower the vehicle.
