Prizm L4-108 1.8L DOHC VIN 8 MFI (1998)
Air Door Cable: Service and Repair
Mode Control Cable
Removal Procedure
1. Remove the center console trim bezel.
2. Remove the knee bolster.
Important: Note the routing of the cable to make installation easier.
3. Remove the mode control cable from the heater case.
4. Remove the two screws (5) and the pull the heater control unit forward.
5. Remove the mode control cable (4) from the heater control unit.
Installation Procedure
1. Position the mode control cable in the vehicle. Route the cable as previously noted.