Prizm L4-108 1.8L DOHC VIN 8 MFI (1998)
Turn Signal Switch: Service and Repair
Steering Wheel and Column - Standard
REMOVAL PROCEDURE
CAUTION: Before removing or installing any electrical unit or when a tool or equipment could easily come in contact with "live" exposed
electrical terminals, disconnect the negative battery cable to help prevent personal injury and/or damage to the vehicle or components.
Unless instructed otherwise, the ignition switch must be in the "OFF" or "LOCK" position.
1. Disconnect the negative battery cable.
CAUTION: When you are performing service on or near the SIR components or the SIR wiring, you must disable the SIR system. Refer
to Disabling the SIR System. Failure to follow the correct procedure could cause air bag deployment, personal injury, or unnecessary SIR
system repairs.
2. Disable the SIR System. Refer to DISABLING THE SIR SYSTEM in SIR.
3. Remove the following components from the steering column:
^
The lower trim cover screw
Important: It is not necessary to remove the steering wheel to access the lower trim cover screws. The screws can be easily accessed by
rotating the steering wheel.
^
The two lower trim cover screws (2) that are located beneath the steering wheel (1).
4. The steering column lower trim cover (6)
