Prizm L4-108 1.8L DOHC VIN 8 MFI (1998)
11. Remove the two bolts from the two EVAP pipe support brackets at the rear of the vehicle.
12. Remove the one bolt from the EVAP pipe front bulkhead support.
13. Slide the ends of the two EVAP pipes out of the EVAP bracket (1) located at the center of the underbody near the EVAP canister.
14. Remove the two EVAP pipes from the vehicle underbody.
Installation Procedure
1. Install the two EVAP pipes to the vehicle underbody.
2. Insert the ends of the two EVAP pipes into the EVAP bracket (1) located at the center of the underbody near the EVAP canister.
3. Install the EVAP/fuel pipe protector (1) to the vehicle underbody.
Notice: Refer to Fastener Notice in Cautions and Notices.
4. Install the four nuts (2) and the one bolt to the EVAP/fuel pipe protector (1).
Tighten
