Prizm L4-108 1.8L DOHC VIN 8 MFI (1998)
Accelerator Pedal: Service and Repair
Accelerator Controls Pedal Replacement
Removal Procedure
1. Disconnect accelerator cable from accelerator pedal lever.
2. Remove the two bolts (3).
3. Remove the accelerator pedal and the pedal lever from vehicle.
4. Remove the one retainer, spring, pin and accelerator pedal from pedal lever.
Installation Procedure
1. Connect the accelerator pedal to pedal lever; secure with one pin, spring and retainer.
2. Connect the accelerator pedal and pedal lever to vehicle.
Notice: Refer to Fastener Notice in Cautions and Notices.
3. Secure with two bolts (3).
Tighten
Tighten the accelerator pedal bracket bolts to 10 N.m (89 lb in).
4. Connect the accelerator cable to accelerator pedal lever.