Prizm L4-108 1.8L DOHC VIN 8 MFI (1998)
Knock Sensor: Service and Repair
Knock Sensor Replacement
Removal Procedure
1. Remove the air intake manifold.
Knock Sensor (KS)
2. Disconnect the knock sensor (KS) electrical connector (2).
3. Remove the KS (1) from the engine block.
Installation Procedure
Notice: Refer to Fastener Notice
Knock Sensor (KS)
1. Install the KS (1) to the engine block.
Tighten
Tighten the KS to the engine block to 39 N.m (29 lb ft).
2. Connect the KS electrical connector (2).
3. Install the air intake manifold.