Prizm L4-108 1.8L DOHC VIN 8 MFI (1998)
14. Disconnect the outer tie rod from the knuckle using the J24319-B.
15. Remove the two nuts and the two bolts from lower side of the strut assembly.
16. Remove the steering knuckle with the hub.
17. Clamp the steering knuckle in a soft jawed vise.
18. If removing the steering knuckle in order to remove the wheel hub, bearing, and seal, refer to WHEEL HUB, BEARING, AND SEAL
REPLACEMENT.
19. If replacing the steering knuckle (2), remove the steering knuckle cotter pin (5) and the ball stud nut (4).
20. Remove the ball stud (3) from the steering knuckle using the J 24319-B.
21. Remove the wheel hub, bearing, and seal, refer to WHEEL HUB, BEARING, AND SEAL REPLACEMENT.
INSTALLATION PROCEDURE
1. Clamp the steering knuckle in a soft jawed vise.
