Prizm L4-108 1.8L DOHC VIN 8 MFI (1998)
11. Inspect the steering knuckle for bearing backlash and hub deviation. Refer to WHEEL BEARINGS DIAGNOSIS in SUSPENSION GENERAL
DIAGNOSIS.
12. Install the front brake rotor. Refer to BRAKE ROTOR REPLACEMENT in DISC BRAKES.
13. Install the brake caliper housing and the caliper bracket. Refer to BRAKE CALIPER BRACKET REPLACEMENT in DISC BRAKES.
14. Install the drive shaft nut while an assistant applies the brakes.
Tighten
Tighten the nut to 225 Nm (166 ft. lbs.).
15. Install the following components:
^
The drive shaft nut retainer
^
The cotter pin
16. Install the following components to the control arm:
^
The one bolt
^
The two nuts
Tighten
Tighten the bolt and the two nuts to 142 Nm (105 ft. lbs.).
