R 10 P/U 2WD V8-454 7.4L (1987)
Fuel Injector: Service and Repair
Fuel Injector Removal (4 Cylinder Models Similar)
REMOVAL
1.
Relieve fuel pressure. Refer to "Fuel Pressure Relief Procedure".
2.
Disconnect battery ground cable, then remove air cleaner assembly.
3.
Disconnect injector(s) connector by squeezing two tabs together and pulling straight up.
4.
Remove fuel meter cover. Refer to "Fuel Meter Cover, Replace". Do not remove meter cover gasket from fuel meter body.
5.
Pry injector out of fuel meter body using a suitable screwdriver and bar stock, Fig. 339.
6.
Remove and discard O-rings, washers, injector fuel filter and meter cover gasket.
