End Gate Lock Cylinder Rattling Solution for S10/T10 Blazer 2WD L4-121 20L VIN Y 2-bbl (1983)
If the spring breaks while bending, it will be necessary to replace the lock cylinder assembly
7.
Reinstall the spring in the lock assembly. Next, shake the assembly to check for looseness. If loose, replace the lock cylinder assembly.
8.
Reinstall the gasket, lock cylinder and retainer (Figure 3, Items 3, 4 and 2).
9.
Reconnect the end gate lock rods (Figure 2, Items 1 and 2).
10.
Reinstall the end gate inner panel reinforcement to the end gate (Figure 1, Item 1).
11.
Reinstall the inner trim panel.
WARRANTY INFORMATION
For vehicles repaired under warranty use:
Labor Op:
B5810
Use applicable labor time guide for labor hours.
