S10/T10 Blazer 2WD V6-262 4.3L VIN Z (1994)
Hose/Line HVAC: Service and Repair
Compressor And Condenser Hose Routing-Utility
REMOVE OR DISCONNECT
1. Negative battery cable.
2. Discharge and recover refrigerant from the system.
3. Bolt (7) and washer (8).
4. Hose assembly (3) from compressor (1).
5. Sealing washers. Refer to "Compressor Sealing Washers."
6. Hose assembly (3) from accumulator (6).
7. O-ring seal.
8. Hose assembly (3) from condenser (4).
9. O-ring seal.
-
Cap or plug all open connections.
INSTALL OR CONNECT
NOTICE: For steps 2, 4, and 7, refer to "Fasteners" under "Vehicle Damage Warnings."
1. New O-ring seal.
-
Coat O-ring seal with 525 viscosity refrigerant oil.
2. Hose assembly (3) to condenser (4).
-
Tighten hose assembly (3) to 24 Nm (18 lbs. ft.).
3. New O-ring seal.
