chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Fuel Injector Cleaning Procedure|Page 3548 > < Fuel Injector Cleaning Procedure
Page 1
background image

Fuel Injector: Service and Repair
Fuel Injector(S) Replacement

CAUTION  

-

Each fuel injector is serviced as a complete assembly only.

-

Use care in removing the fuel injectors to prevent damage to the electrical connector terminals, the injector filter, and the fuel nozzle.  The fuel
injector is serviced as a complete assembly only. Also, since the injectors are electrical components, they should not be immersed in any type of
liquid solvent or cleaner as damage could occur.

Fuel Injector Removal

REMOVE/DISCONNECT

-

Electrical connectors to fuel injectors. (Squeeze plastic tabs and pull straight up.)

-

Fuel meter cover assembly. See: Throttle Body/Service and Repair/Fuel Meter Cover Assembly

-

With fuel meter cover gasket in place to prevent damage to casting, use a screwdriver and fulcrum to carefully lift out each injector.

-

Lower (small) O-rings from nozzle of injectors and discard.

-

Fuel meter cover gasket and discard.

-

Upper (large) O-rings and steel backup washers from top of fuel injector cavity and discard.

INSPECT 

Fuel injector filter for evidence of dirt and contamination. If present, check for presence of dirt in fuel lines and fuel tank. If dirt is present refer to 
FUEL SYSTEM CLEANING.

Fuel Injector Part Number Location

NOTE

Be sure to replace the injector with an identical part. Different injectors with different flow rates will fit this unit, but are calibrated for different flow
rates.

Fuel Injector Cleaning Procedure|Page 3548 > < Fuel Injector Cleaning Procedure