S10/T10 Blazer 2WD V6-262 4.3L VIN Z (1994)
B. Position switch on column and push against dimmer switch rod (45) to remove all lash.
C. Remove drill bit.
TIGHTEN
^
Tighten screw (44) and nut (42) to 4.0 Nm (35 lb.in.).
17. Do all steps, "INSTALL OR CONNECT", for "UPPER COLUMN".
Ignition Lock Cylinder & Upper Column Components - Column Shift
INCLUDES:
STEERING COLUMN LOCK CYLINDER SET
STEERING SHAFT LOCK
TURN SIGNAL CANCELLING CAM ASSEMBLY
UPPER BEARING SPRING
THRUST WASHER
TURN SIGNAL SWITCH ASSEMBLY
BUZZER SWITCH ASSEMBLY
TOOLS REQUIRED:
^
J 23653-C Lock Plate Compressor
IMPORTANT
^
Before doing any service procedures in this section, removal of Steering Wheel is needed.
Fig. 13 Exploded View Of Standard Steering Column W/ Column Shift
