S10/T10 Blazer 2WD V6-4.3L VIN X (2003)
1. Install sensor into the hub and bearing assembly (6).
Tighten the sensor mounting screw (5) to 18 Nm (13 ft. lbs.).
Important: The new sensor has new mounting clips already installed on the wire. DO NOT reuse the old clips.
2. Connect the wheel speed sensor electrical connector (2).
3. Install wheel speed sensor mounting clip to the frame rail.
4. Install the wheel speed sensor mounting clip to the control arm.
5. Install the hub and rotor.
6. Install brake caliper.
7. Install tire and wheel.
8. Lower the vehicle. Refer to Vehicle Lifting.
