S10/T10 Blazer 2WD V6-4.3L VIN X (2003)
Notice: Refer to Fastener Notice in Service Precautions.
2. Seat the taper using J 29193 or J 29194.
Tighten J 29193 or J 29194 to 54 Nm (40 ft. lbs.)
3. Remove J 29193 or J 29194 from relay rod ball stud.
4. Install the new nut to the relay rod ball stud at the idler arm.
Tighten the relay rod ball stud nut at the idler arm to 47 Nm (35 1b inch).
5. Install the relay rod ball stud to the pitman arm. Ensure that the seal is on the stud.
6. Seat the taper using J 29193 or J 29194.
Tighten J 29193 or J 29194 to 54 Nm (40 ft. lbs.).
7. Remove J 29193 or J 29194 from relay rod ball stud.