S10/T10 Blazer 4WD V6-262 4.3L (1989)
Remove or Disconnect
^
Clamp J 34992 in a vise and attach the compressor to the holding fixture with thumb screws.
Removing The Shaft Nut
1. Shaft nut (21) using J 33022.
^
Hold the clutch plate and hub assembly (22) steady using J 33027-A.
2. Clutch plate and hub assembly (22).
^
Thread J 33013-B into the clutch plate and hub assembly (22).
Removing The Clutch Plate & Hub Assembly
^
Hold the body of J 33013-B with a wrench and tighten the center screw into the remover body.
3. Shaft key (23).
^
Retain shaft key (21) if usable.
Inspect
^
All parts and replace as necessary.
Install Or Connect
1. Shaft key (23) into the hub key groove.