S10/T10 Blazer 4WD V6-262 4.3L (1989)
Alignment: Specifications
(Figure 1) Front End Alignment Specifications
NOTE: Vehicle must be jounced three times before checking alignment to eliminate false geometry readings.
(A) Front suspension "Z" dimension and rear suspension "D" dimension are held as indicated in Adjustments / Curb Trim Heights. See: Service and
Repair/Ride/Trim Height Measurement and Adjustment
Front end alignment specifications are indicated in (Figure 1).
(B) Left and right side to be equal within 0.50 degree.
(C) Left and right side to be equal within 1.0 degree.
(D) Toe-in-left and right side to be set separately per wheel and steering wheel must be held in straight ahead position within ± 5.0 degree.