S10/T10 Blazer 4WD V6-262 4.3L (1989)
Figure 1 - Fuel Tank Installation
8.
Reinstall fuel tank (Figure 1).
A.
Raise tank sufficiently to install fuel tank sending unit hoses, electrical connector, and ground strap. Route strap 1 under hoses and wiring.
B.
Raise tank fully and install tank supports (5). Torque front strap nuts (9) to 27-47 N-m (20-35 lbs.ft.). Torque support nuts (7) to 40-50 N-m
(29-37 lbs.ft.).
C.
Reinstall tank shield and torque screws to 9-13 N-m (80-115 lb.in.).
9.
Lower vehicle, refill fuel, connect battery negative ground cable.
10.
Start engine and check for fuel leaks.
SERVICE PARTS INFORMATION
Part Number
Description
Quantity
15674914
Rear Frame Crossmember and Shock Tower
1
Assembly
11504596
Bolt, Crossmember Mounting,
6
11501033
Nut, Crossmember Mounting,
6
15531204
Washer,
12
Parts are currently available from GMSPO.
WARRANTY INFORMATION
For vehicles repaired under warranty use:
Labor Operation:
T7186
Labor Time:
2.5 hrs.
Trouble Code:
92
NOTE:
Labor Operation is coded to base vehicle coverage in the warranty system.
