S10/T10 Blazer 4WD V6-262 4.3L (1989)
15.
Insert a drift-through brake caliper to prevent drive axle from turning and torque inboard flange bolts to 80 N-m (60 lbs.ft.).
16.
Torque hub nut to 220-270 N-m (162-199 lbs.ft.).
17.
Attach retainer.
18.
Align cotter pin hole with retainer slot by rotating retainer.
Important:
DO NOT back off or tighten hub nut more than specified to install cotter pin.
19.
Install new cotter pin. Cotter pin must be bent so retainer is held snugly to prevent rattling.
20.
Remove drift, install wheels, and lower vehicle.
Service Parts Information:
Part Number
Description
Quantity Required
26027964
Seal Kit, Tripot
1 per side
Parts are expected to be available on June 17, 1991. Until then, normal part orders will not be accepted by GMSPO. Only verifiable emergency VIP
orders will be accepted. GMSPO will make every effort to obtain parts. All parts will be placed on 400 control to waive VIP surcharges. However, the
parts will be shipped premium transportation at dealer's expense. All other order types will be cancelled as incorrectly ordered while 400 control is in
place.
Warranty Information:
For Vehicle repaired under warranty use:
Labor Operation:
T7271
Labor Time:
1.6 hrs. each side
Trouble Code:
92