S10/T10 Blazer 4WD V6-262 4.3L (1989)
Wiper Motor: Service and Repair
Rear Wiper Motor
Figure 28
Figure 29
REMOVE OR DISCONNECT
1. Battery ground cable.
2. Retainer screws (10) and cover (9) from the wiper motor (1).
3. Wiper arm assembly (8) from the wiper motor (1).
NOTE: For ease of removal and installation of the wiper arm assembly install an 1/8 drift pin through the wiper arm hinge to control the spring
detent. Refer to Figure 28.
4. Washer hose from the wiper arm assembly.
5. Glass support arm from the end gate glass and support the end gate glass.
