S10/T10 Blazer 4WD V6-262 4.3L VIN W CPI (1992)
27. Balance shaft rear bearing using J 38834 and J 26941.
Important
-
The balance shaft and both bearings are serviced only as a complete package.
-
Use only the correct tools for bearing and shaft installation.
-
The front bearing must not be removed from the balance shaft.
-
The balance shaft drive and driven gears are serviced only as a set. The set includes the balance shaft driven gear bolt.
Clean
-
All traces of old gasket material from gasket sealing surfaces.
Inspect
-
Balance shaft drive and driven gears for nicks and burrs.
Install
Tools Required:
J 23523-E Torsional Damper Puller and Installer.
J 38834 Balance Shaft Bearing Service Kit.
J 36996 Shaft Installer
J 8092 Driver Handle
J 35468 Crankshaft Seal Installer