S10/T10 Blazer 4WD V6-262 4.3L VIN W CPI (1992)
Control Cable
REMOVE OR DISCONNECT
1. Screws (64).
2. Control assembly (63).
NOTICE: Pull control assembly (63) out of the instrument panel far enough to reach the control cable assembly ends arid the blower switch
electrical connector.
3. Electrical connection (82).
4. Control cables (60 and 65).
5. Blower switch if necessary.
NOTICE: Remove the blower switch knob and spring clip, and remove the blower switch.
Inspect
-
Electrical terminals for corrosion. Remove the corrosion or replace the component as necessary.
-
Temperature and mode levers for freedom of movement. Lubricate, repair or replace as necessary.
-
Control cable assemblies for kinks, binding and other damage. Repair or replace as necessary.
INSTALL OR CONNECT
1. Heater blower switch if removed.
-
Hold the blower switch in position and install the spring clip.