S10/T10 Blazer 4WD V6-262 4.3L VIN W CPI (1992)
3.
Using the template provided, check the float arm angle (Figures 2 and 3). If the angle does not match the template, grasp the fuel sender with pliers
and bend the float arm until it matches the template (angle equals 87 degrees).
DAMAGE TO THE GAUGE READOUT WILL OCCUR IF THE SENDER IS NOT HELD PROPERLY DURING THE BENDING
PROCEDURE.
4.
Install the fuel sender assembly as outlined in the "FUEL PUMP Install" section in the 1992 Light Duty Truck Service Manual.
Important:
THE FUEL SENDER SEAL RING MUST BE REPLACED (P/N 3893116).
5.
Install the fuel tank as outlined in the "FUEL TANK Replacement" section, in the 1992 Light Duty Truck Service Manual.
Important:
TIGHTEN THE UPPER TANK STRAPS LAST, TORQUE TO 5.5-8.0 N-m 4.0-6.0 lbs.ft.
SERVICE PARTS INFORMATION
Part Number
Description
Qty.
3893116
Fuel Sender Seal Ring
1
Parts are currently available from GMSPO.
WARRANTY INFORMATION
For vehicles repaired under warranty use:
Labor Operation:
L1225