S10/T10 Blazer 4WD V6-262 4.3L VIN W CPI (1992)
B.
Locate the two grille to fender fasteners at the bottom of the grille (one on each side). These can be either Christmas Tree style retainers or
bolts:
a.
If the grille has Christmas Tree style retainers, it is NOT necessary to remove them.
b. If the grille has two grille to fender bolts, remove them.
C.
Disconnect the side marker lamp connectors.
2.
From the back side of the grille, apply clear G.M.S. sealer (P/N 1052915 or equivalent), along the entire leading edge of the side marker lamp(s)
(Figure 1, View A).
3.
Reinstall the grille.
A.
If the grille is equipped with Christmas Tree style retainers, one on each side of ghlle, snap the grille in place prior to torquing the remaining
fasteners. If required, replace the Christmas Tree style retainers (P/N 15672328).
B.
If the grille is equipped with two grille to fender bolts located at the bottom of the grille, one on each side, instead of Christmas Tree style
retainers, reinstall the bolts and torque them to 1.6 - 2.2 N-m. (13-18 lbs.in.).
C.
Torque the remaining eight fasteners located across the top of the grille and within the egg crate area to 1.2 - 1.6 N-m. (10-13 lbs.in.).
SERVICE PARTS INFORMATION
Part Number
Description
Qty/Veh
1052915
G.M.S. Sealer-Type A
As Required
15672328
Retainer-Radiator Grille
As Required
Parts are currently available from GMSPO.
WARRANTY INFORMATION
For vehicles repaired under warranty use:
Labor Operation:
B1308
Use applicable labor time guide for labor hours.
