S10/T10 Blazer 4WD V6-262 4.3L VIN W CPI (1992)
Idle Speed: Adjustments
NOTE: Before performing this check:
-
Verify no codes displayed.
-
Idle air control system has been checked.
-
Ignition timing is correct.
CONTROLLED IDLE SPEED CHECK
-
Set parking brake and block drive wheels.
-
Connect a SCAN tool to the assembly line data link (ALDL) connect with tool in Open Mode.
-
START engine and bring it to normal operating temperature.
-
Check for correct state of PARK/NEUTRAL switch on SCAN tool.
-
Check specifications chart for controlled idle speed and IAC valve pintle position (counts).
-
If within specifications, the idle speed is being correctly controlled by the control module.
-
If not within specifications, refer to DIAGNOSIS BY SYMPTOM. See: Testing and Inspection
MINIMUM IDLE AIR RATE CHECK
Minimum Idle Air Rate is not adjustable on this engine.
CONTROLLED IDLE SPEED
Transmission
Gear
Idle Speed
IAC Counts [1]
OPEN/CLOSED Loop [2]
Auto
D
550
5-40
CL
[1] Add 2 counts for engines with less than 500 miles. Add 1 count for every 1000 ft. above sea level.
[2] Let engine idle until proper fuel control status is reached (OPEN/CLOSED loop).