S10/T10 Blazer 4WD V6-4.3L VIN W (1997)
Garage Door Opener Transmitter: Service and Repair
Universal Transmitter Module Replacement
Universal Transmitter Module
REMOVE OR DISCONNECT
1. Open the universal transmitter compartment door.
^
Use a flat-bladed tool at the rear of the door to carefully pry the door open.
2. Electrical connector and tape.
3. Screws that retain the universal transmitter module to the door.
4. Universal transmitter module from the door.
Universal Transmitter Module
INSTALL OR CONNECT
1. Universal transmitter module from the door.
2. Screws that retain the universal transmitter module to the door.
Tighten
Screws to 1.9 Nm (17 lb in).
3. Electrical connector and tape.
4. Close the universal transmitter compartment door.