S10/T10 Blazer 4WD V6-4.3L VIN W (1997)
Carpet wet in the rear.
Cause
Sealer under the roof molding may have a void in it. Refer to the illustration shown.
Correction
Test for a leak before removing the roof ditch molding. For pickups, remove the trim and insert air into the inside "C" pillar corner while applying soapy
water to the suspected area of the roof. Dry and seal as necessary. For utilities, test for a void using air forced from inside the vehicle while spraying
soapy water along roof seam. Air can be forced up the "D" pillar behind the trim panel, or through the top weatherstrip attachment hole in the "B" pillar
for two-door utilities and behind the trim on "C" pillar for four-door utilities. Refer to the illustration shown. Clean the area with one of the cleaners
listed and seal the area with one of the sealers listed.
Condition 9
Carpet wet in the rear and or in the corners at the base of the "C" pillar.
Cause
