S10/T10 Blazer 4WD V6-4.3L VIN W (1997)
2. Use a feeler gauge to check the clearence between the three oil pan-to-transmission contact points. If the clearance exceeds 0.0254 mm (0.010 in)
at any of the three points, repeat the installation steps until the clearence is within specifications.
3. Install the starter motor.
4. Install the oil filter adapter.
5. Install the oil cooler lines.
6. Roll the differential back into position and install the front differential through bolts.
7. Install the front propeller shaft.
8. Install the front underbody shield.
9. Install the front axle shield.
10. Lower the vehicle.
