S10/T10 Blazer 4WD V6-4.3L VIN W (1997)
2. Control assembly screws.
3. Control assembly.
4. Vacuum connectors, as necessary.
5. Electrical connectors, as necessary.
INSTALL OR CONNECT
1. Electrical connectors, as necessary.
2. Vacuum connectors, as necessary.
3. Control assembly.
NOTICE: Refer to "Fasteners" under "Vehicle Damage Warnings."
4. Control assembly screws.
-
Tighten screws to 1.9 Nm (17 lbs. in.).
5. Accessory trim plate.
-
Perform "Heater Function Test."
With A/C
Control Assembly
Vacuum Harness
REMOVE OR DISCONNECT
