S10/T10 Blazer 4WD V6-4.3L VIN W (1997)
^
Tighten the nuts to align the cotter pin. Do not tighten more than 1/6 turn.
5. New cotter pins.
^
Bend the pin ends against the nut flats.
6. Splash shield aligned to the knuckle.
7. Hub and bearing assembly.
^
Align the threaded holes.
8. Bolts.
Tighten:
^
Bolts to 105 Nm (77 lb. ft.).
9. Tie rod end to the knuckle.
10. Nut.
Tighten:
^
Nut to 53 Nm (39 lb. ft.).
11. New cotter pin.
^
Bend the pin ends against the nut flats.
12. Rotor. Refer to "Rotor Replacement."
13. Brake caliper.
14. Washer.
15. Nut.
^
Insert a drift or large screwdriver through brake caliper into rotor vanes to prevent from turning.
Tighten:
^
Drive axle nut to 140 Nm (103 lb. ft.).
16. Tire and wheel.
A. Lower the vehicle.
B. Apply the brake pedal.
C. Check vehicle trim height and align the front end.
