chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Deployed Inflator Module|Page 10554 > < Deployed Inflator Module|Page 10552
Page 5
background image

10. Remove all of the horn buttons and redundant steering wheel control buttons from the inflatable restraint steering wheel module, if applicable.

11. Caution: When you are carrying an undeployed inflator module:

-

Do not carry the inflator module by the wires or connector on the inflator module.

-

Make sure the bag opening points away from you.

When you are storing an undeployed inflator module, make sure the bag opening points away from the surface on which the inflator module
rests. When you are storing a steering column, do not rest the column with the bag opening facing down and the column vertical Provide free
space for the air bag to expand in case of an accidental deployment. Otherwise, personal injury may result.

Place the inflator module with its vinyl trim covering facing up and away from the surface on a work bench or another surface.

12. Place the inflator module away from all loose or flammable objects.

13. Clear a space on the ground about 1.85 m (6 ft) in diameter where you intend to deploy the inflator module. If possible, use a paved, outdoor

location free of activity. Otherwise, use a space free of activity on the shop floor. Make sure you have sufficient ventilation.

14. Make sure that no loose or flammable objects are within the deployment area.
15. Place the inflator module in the space cleared, with its vinyl trim cover facing up.

16. Extend the SIR deployment harness and the pigtail adapter to full length from the inflator module.
17. Place a power source near the shorted end of the SIR deployment harness. Use a vehicle battery when available, but always use a power source

that complies to the following:
-

12 volts minimum

-

2 amps minimum

18. Important: Firmly seat the pigtail adapter into the inflator module connector. Failure to fully seat the connectors may result in non-deployment of

the inflator module.
Connect the inflator module to the pigtail adapter on the SIR deployment harness.
-

The deployment harness shall remain shorted until you are ready to deploy the air bag.

Deployed Inflator Module|Page 10554 > < Deployed Inflator Module|Page 10552