S10/T10 Blazer 4WD V6-4.3L VIN W (1997)
-
Tighten nut to 60 Nm (44 ft. lbs.).
3. Cotter pin. Bend out the ends of the cotter pin.
4. Steering Shock absorber ball stud to the relay rod.
-
Make sure the seal is on the stud. Tighten J 29193 or J 29194 to 54 Nm (40 ft. lbs.) in order to seat the taper.
5. Nut.
-
Tighten nut to 63 Nm (46 ft. lbs.).
