S10/T10 Blazer 4WD V6-4.3L VIN W (1997)
Housing End Plug
REMOVE OR DISCONNECT
-
Steering gear from vehicle.
DISASSEMBLE
NOTE: Rotate stub shaft back and forth to drain fluid.
1. Retaining ring (1) by using a punch inserted into the housing access hole to unseat it.
2. Plug (2).
3. O-ring seal (3).
ASSEMBLE
NOTE: Lubricate O-ring seal with power steering fluid.
1. O-ring seal (3) into housing (20).
2. Plug (2).
3. Retaining Ring (1).
-
Install retaining ring (1) so that open end is approximately 25 mm (1 inch) from access hole in housing (20).
INSTALL OR CONNECT
-
Steering gear.
Adjuster Plug Assembly Replacement
