S10/T10 Blazer 4WD V6-4.3L VIN W (1997)
2. Adjuster nut (65) from housing (20) using J 7624.
3. Thrust support assembly (49) and O-ring seals (56).
4. O-ring seal (56)
ASSEMBLE
-
Lubricate O-ring seal (56).
1. Install O-ring seal (56).
2. Thrust support assembly (49).
3. Adjuster nut (65) to housing (20) using J 7624.
4. Coupling shield ret. and lock nut (48) to adjuster nut (65)
Adjust
-
Thrust bearing preload.
5. Install coupling shield ret. and lock nut (48), and using a drift in a notch, tighten securely.
-
Hold adjuster nut (65) to maintain alignment of the marks.
Adjust
-
Pitman shaft over-center sector.
INSTALL OR CONNECT
-
Power steering gear.
Valve Replacement
