S10/T10 Blazer 4WD V6-4.3L VIN W (1997)
1. Cotter pins and nuts.
2. Outer tie-rod ball studs from the steering knuckle using J 6627-A.
NOTICE: Do not attempt to disengage the joint by driving a wedge-type tool between the joint and knuckle. Seal damage could result.
3. Inner tie rod ball studs from the relay rod using J 6627-A.
4. Tie rod ends from the adjuster tube.
-
Loosen the clamp bolts and unscrew the assemblies.
INSPECT
-
Tie rod end for damage.
-
Tie rod end seals for excessive wear.
-
Threads on the tie rod and tie rod end for damage.
-
Ball stud threads for damage.
-
Adjuster tube for bending or damaged threads.
CLEAN
