S10/T10 Blazer 4WD V6-4.3L VIN W (1997)
Clutch Pedal Assembly: Service and Repair
REMOVAL PROCEDURE
Push Rod
1. Remove the push rod from the clutch pedal.
Clutch Pedal Assembly
2. Remove the following:
-
The clutch pedal bolt
-
The clutch pedal
-
The spring
-
The bushings
-
The spacer
INSTALLATION PROCEDURE
1. Install the following clutch pedal items:
-
A new spacer.
-
New bushings.
-
The spring.
-
The clutch pedal.
-
The clutch pedal bolt.
Important: Install the bolt in the direction shown.
-
Tighten the clutch pedal bolt to 37 Nm (27 ft. lbs.).
2. Install the push rod to the clutch pedal.
3. Check the clutch system for proper operation.