S10/T10 Blazer 4WD V6-4.3L VIN W (1997)
Four Wheel Drive Indicator Lamp: Service and Repair
Manual Shift Transfer Case
Description
Description
Remove or Disconnect
-
Make sure the headlamp switch is in the OFF position.
-
Make sure the ignition switch is in the LOCK position.
1. Floor console.
2. Electrical connectors from the indicator lamp assembly.
3. Screws that retain the indicator lamp assembly to the floor console.
4. Indicator lamp assembly from the floor console.
5. Bulb(s) from the lamp assembly.
Install or Connect
1. Bulb(s) to the lamp assembly.
2. Indicator lamp assembly to the floor console.
3. Screws that retain the indicator lamp assembly to the floor console.
Tighten
-
Screws to 1.9 Nm (17 lb in).
4. Electrical connectors from the indicator assembly.
5. Floor console.
