S10/T10 Blazer 4WD V6-4.3L VIN W (1997)
Four Wheel Drive Selector Switch: Service and Repair
New Venture Gear 231 Transfer Case
REMOVE OR DISCONNECT
1. Negative battery cable.
2. Front floor console.
3. Switch connector from the wiring harness connector.
4. Two screws securing the switch to the bracket.
5. Switch from the bracket.
INSTALL OR CONNECT
1. Switch to the bracket.
-
Ensure that the switch contact slide is aligned with the actuating pin on the lever.
2. Switch to the bracket with two screws.
-
Tighten switch to bracket screws to 4 Nm (35 inch lbs.).
3. Switch harness to the indicator assembly.
4. Front floor console.
5. Negative battery cable.
