S10/T10 Blazer 4WD V6-4.3L VIN W (1997)
Description
Install or Connect
IMPORTANT: Replacement Inserts have three plastic caps that retain the two metal flexor strips. Do not remove these caps before the insert is
installed.
1. At end "A" of the blade assembly. slide the insert (notched end last) into the blade claws. The plastic caps will be forced off as the insert is fully
inserted.
2. Be certain that the notches are locked by the bottom claws and that all other claws are properly engaged in the slots of the insert on both sides.
3. Position pivot of blade assembly into hook of the wiper arm and pull upward until the locking tab of the pivot engages the slot in the hook.
4. Carefully lower wiper arm and blade assembly onto the windshield.
Inspect Wiper Operation
^
Perform System Check.
