S10/T10 P/U 2WD L4-119 1.9L VIN A 2-BBL (1984)
FIGURE 1 - TRANSMISSION OIL PAN
FIGURE 2 - HEX HEAD SCREW AND CONICAL WASHER ASSEMBLY
3.
Replace the former oil pan, (Figure 1) hex head screws (Figure 2) and gasket with new oil pan (Figure 1) and hex head screw and conical washer
assemblies (Figure 2). Order service package 8642999.
The service package contains the following:
1 - New Oil Pan
16 - New Hex Head Screw and Conical Washer Assembly
1 - Gasket
These parts are also available separately:
P/N 8647498
New Oil Pan
P/N 8654095
New Hex Head Screw & Conical Washer
Assembly
P/N 8642360
Gasket
4.. When replacing the oil pan, it is critical that a torque wrench is used to tighten the hex head screws. DO NOT USE IMPACT WRENCH!
Torque all hex head screws to 11.0 N.m (9.0 ft. lbs.), then retorque all the hex head screws a second time to the same specifications as above. The second
retorque is important because the gasket material relaxes after the first tightening.