S10/T10 P/U 2WD L4-121 2.0L VIN Y 2-bbl (1983)
Windshield Washer Spray Nozzle: All Technical Service Bulletins
Windshield Washer - Spray Pattern Too Low
Number:
87-110
Section:
10 - Body Section
Date:
April, 1987
Subject:
WINDSHIELD WASHER SPRAY PATTERN
Model and Year:
1983-1987 S/T MODELS
FIGURE 1
Some 1983-87 S/T trucks may experience a windshield washer spray pattern that is too low on the windshield. This condition usually occurs when the
vehicle is being driven at highway speeds. To repair this condition, a new cowl vent grille screen (Figure No. 1), P/N 15602771, has been released. This
screen has a 1/4 inch vertical tab on its rear edge that raises the rear edge of the cowl grille panel. The windshield washer nozzle, which is part of this
grille panel, will subsequently spray the windshield 3 to 6 inches higher than a vehicle equipped with the original screen.
The following procedure should be used when performing this operation.
SERVICE PROCEDURE
^
Remove windshield wiper arms.
^
Raise hood.
^
With masking tape, tape the lower edges of the grille panel, the hood flange at the grille panel, and the fenders at the grille panel. This is to
ensure there is no paint damage to the surrounding sheet metal when the grille panel is removed.
^
Remove the grille panel fasteners.
^
Disconnect the windshield washer hose at the nozzel.
^
Carefully remove the grille panel from the vehicle.
^
Remove and discard cowl vent grille screen.
^
Install new screen.
^
Reinstall grille panel and reconnect washer hose.