S10/T10 P/U 2WD L4-2.2L VIN 4 (1995)
Hand Crimp Tool
Using the J 38125-8 splice crimp tool, position the splice sleeve in the proper color nest of the hand crimper tool. Place the splice sleeve in the
nest so that the crimp rails midway between the end of the barrel and the stop.
Seal Splice Sequence
The sleeve has a stop in the middle of the barrel to prevent the wire from going further. Close the hand crimper handles slightly to hold the splice
sleeve firmly in the proper nest
Seal Splice Sequence
Step Five: Insert Wires into the Splice Sleeve and Crimp
Insert the wire into the splice sleeve until it hits the barrel stop, and close the handles of the J 38125-8 crimper tightly until the crimper handles
open when released. The crimper handles will not open until the proper amount of pressure is applied to the splice sleeve. Repeat steps 4 and 5 for
opposite end of the splice.