S10/T10 P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
1. Install the brake pads.
Important: Lift the inner edge caliper boot next to the piston. Press out any trapped air. The boot must lay flat below the level of the piston face.
2. Install the caliper over the rotor and into the anchor bracket.
3. Lubricate the guide pin bolts with Delco Silicone Lube (GM P/N 18010909) or equivalent.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the caliper guide pin bolts to the caliper bracket.
-
Tighten the caliper guide pin bolts to 31 Nm (23 ft. lbs.).
Notice: Refer to Brake Hose Installation Notice in Service Precautions.
